移动存储

产品展示

Initio INIC1610P

Initio INIC1610P

产品分类:移动存储

  • 产品说明

1 Introduction
 
The INIC-1610P provides an advanced solution to connect SATA devices to USB or SATA Host with integrated CPU and embedded SRAM.  To provide high performance and cost effective solution, the INIC-1610P integrates USB-PHY Mass Storage Class Bulk-Only USB function, SATA transport/link/PHY core and microprocessor into a single ASIC. The INIC-1610P provides the data transfer rate of up to 60 MB/sec connecting to a 3.0G SATA interface. 
 
1.1 Feature Summary
 • Integrates USB2.0 PHY IP core. 
 
• Data transfer rate of up to 60 MB/sec on USB side, 300 MB/sec on SATA side.
 
• Integrated internal Turbo 8051 uP with 32KB embedded SRAM.
 
• Program Flash In-Line (Firmware download mechanism, USB direct for MFG Test, write .bta file.
 
• Local Bus Interface to Serial Peripheral Interface (SPI) Flash Only.
 
• Supports HID. 
 
• Up to 14 GPIO pins. 
 
• Provides software utilities for downloading the upgraded firmware code under USB.
 
• Use a single crystal for both USB and SATA
 
• Supports SATA (bridged SATA) Hard Disk drives, CD-RW devices, DVDs, Removable media devices, BD(Blu-Ray Disc) drive.
 
• USB 1.1 and USB 2.0 compliant.
 
• USB Mass Storage Class Bulk-Only Transport Specification Compliant.
 
• Serial ATA Revision 2.6 Specification Compliant (Hot Plug is supported).
 
• Supports SATA to SATA pass through with HID.   

• Supports ATA/ATAPI device DMA and PIO mode.

• Two SATA channels support
 
• Supports 3Gbps SATA HDD connection
 
• 4k bytes of data buffer for data transfer.
 
• Support Generic SPI module
 
• Support PWM module for LED control
 
• On-chip 3.3V to 1.2V regulator and 5.0V to 3.3V regulator. 
 
•  64 pin LQFP